Front Panel I/O Device Assembly
1
Disconnect power from the system
front bezel
2
Unlatch the plastic snap that secures the cables inside the chassis and disconnect the front panel I/O
device assembly cables from the system board.
3
Remove the screws that hold the front panel I/O device assembly and bracket to the chassis and
remove the screws that hold the front panel I/O device assembly to the bracket.
4
Pull the front panel I/O device assemblyout about two inches away from the chassis.
5
Separate the bracket away from the front panel I/O device assembly.
WARNING!
The next step requires the removal of cables through the chassis. Some edges on the
chassis might be sharp. Be careful when removing these cables.
6
Slide the front panel cables through the chassis and out the front of the unit.
To replace the front panel I/O device assembly, reverse the previous steps.
78 REMOVAL AND REPLACEMENT PROCEDURES
(page
75).
(page
68), remove the access panel
(page
74), and remove the