Installing The Front Panel I/O Cable Assembly - HP Z600 Maintenance And Service Manual

Installing the front panel I/O cable assembly

1. With power removed and the chassis open, guide the front panel I/O cable assembly cables through
the chassis openings from which they were removed.
2. Place the front panel I/O cable assembly in the chassis and guide it into position as shown in the
following figure
Figure 5-15
3. Connect the front panel I/O cable assembly cables to the system board as shown in the following
figure.
Figure 5-16
Table 5-6
Item
4. Reconnect the speaker cable (see
that secure the front panel I/O cables to the chassis.
5. Reinstall all removed components and reconnect all cables that have been disconnected.
ENWW
. Install the screw
Installing the front panel I/O cable assembly
Connecting the front panel I/O cable assembly cables
Front panel I/O cable assembly connectors
Description
1 Front audio
2 Front USB
.
2
Installing the speaker on page
Removing and installing components
80), and replace the tie wraps
87