Front Panel I/O Device Assembly - HP Xw4550 - Workstation - 2 GB RAM Technical Reference Manual

1. Disconnect power from the system
bezel (Front Bezel on page
2. Gently push the subpanel (1) out the back of the front bezel.
3. Remove the desired bezel blank by applying outward pressure on the subpanel (1) and pulling the
blank (2) away.
Figure 4-9
NOTE: The bezel blanks are keyed to assist you in replacing the blanks. Also, the subpanel can be
rotated 90 degrees to install the optical drives in desktop orientation if desired.

Front panel I/O device assembly

To remove the front panel I/O device assembly:
1. Disconnect power from the system
access panel
on page
2. Unlatch the plastic snap that secures the cables inside the chassis and disconnect the front panel
I/O device assembly cables from the system board.
3. Remove the two smaller Torx screws (1) that hold the front panel I/O device assembly (3) and
bracket to the chassis.
4. Remove the two larger Torx screws (2) that hold the front panel I/O device assembly (3) to the
bracket.
5. Separate the bracket away from the front panel I/O device assembly.
6. Pull the front panel I/O device assembly out about two inches away (4) from the chassis.
ENWW
62).
Removing the bezel blanks
(Side access panel on page
62).
(Predisassembly procedures on page
(Predisassembly procedures on page
59), and remove the front bezel
Steps for removing and replacing components
55) and remove the front
55), remove the side
(Front Bezel
63