Removing And Installing The Scsi Backplane; Removing The Scsi Backplane; Installing The Scsi Backplane Board - HP server rx4610 Service Manual

Chapter 6

Removing and Installing the SCSI Backplane

The SCSI Backplane resides on the back of the Hard Drive Bay. It is accessed by removing the Hard Disk
Bay.

Removing the SCSI Backplane

To remove the SCSI Backplane, complete the following steps:
1. Remove the Hard Disk Bay as described in "Removing the Hard Disk Bay" earlier in this
chapter.
2. Disconnect the LCD panel cable from the SCSI Backplane.
3. Remove the cap stabilizer retaining screw and the cap stabilizer. These two items will be used
on the new board.
4. Remove the three screws that secure the SCSI Backplane to the Hard Disk Bay.
5. Carefully place the SCSI Backplane on a clean, anti-static work surface or in anti-static
packaging.

Installing the SCSI Backplane Board

To install the SCSI Backplane Board, complete the following procedure:
1. Carefully align the SCSI Backplane in the slots to the rear of the Hard Disk Bay. Be sure that
the four holes in the SCSI Backplane align with the holes and alignment pin in the bay.
2. Secure the SCSI Backplane to the bay by tightening the three screws.
3. Connect the Front Panel cable to the SCSI Backplane. Open the cable connector lock tabs to a
45 angle before inserting the cable.
4. Position the cap stabilizer and secure it with the cap stabilizer retaining screw.
5. Install the Hard Drive Bay as described in "Installing the Bay" earlier in this chapter.
Figure 48. Removing the SCSI Backplane
Replacing Parts
121