Cisco WAVE-574-K9 - Wide Area Virtualization Engine 574 Hardware Installation Manual page 89

Chapter 6 Troubleshooting the System Hardware
Parity Check 2 - System DIMM Memory
PCI Bus Parity Error, PCI Slot x
Power Fault Detected in Hot-Plug PCI Slot x
Processor X Unsupported Wattage.
Redundant ROM Detected - This system contains a valid backup system ROM.
REDUNDANT ROM ERROR: Backup ROM Invalid. - ......run ROMPAQ to correct error condition.
OL-17738-01
Action: Be sure the memory is installed correctly. Use only Cisco DIMM pairs
when populating memory sockets. See the
page 4-8. If the problem persists, contact the Cisco Technical Assistance Center.
Possible Cause: An uncorrectable error memory event occurred in a memory
DIMM.
Action: Use the DIMM LEDs to identify failed DIMMs and replace the DIMMs.
If the problem persists, contact the Cisco Technical Assistance Center.
Possible Cause: A PCI device has generated a parity error on the PCI bus.
Action: For plug-in PCI cards, remove the card. If the problem persists, contact
the Cisco Technical Assistance Center.
Possible Cause: PCI-X Hot Plug expansion slot was not powered up properly.
Action: Reboot the WAVE appliance.
Possible cause: Processor not supported by current WAVE appliance.
Action: Refer to the WAVE appliance documentation for supported processors. If
the problem persists, contact the Cisco Technical Assistance Center.
Possible Cause: The system recognizes both the system ROM and redundant
ROM as valid. This is not an error.
Action: None
Possible Cause: The backup system ROM is corrupted. The primary ROM is valid.
Action: If the problem persists, contact the Cisco Technical Assistance Center.
Cisco Wide Area Virtualization Engine 574 Hardware Installation Guide
Power-On Self Test (POST)
"Installing Memory" section on
6-19