Table of Contents
Advertisement
Removing the Covers
Warning
Caution
OL-17738-01
Installing Hardware Options for the
WAVE-574
This chapter provides basic instructions for installing hardware options in your
WAVE-574. These instructions are intended for technicians who are experienced
with setting up Cisco WAVE-574 hardware.
This chapter contains the following sections:
Removing the Covers, page 4-1
•
Completing the Installation, page 4-2
•
Installing a Cisco WAVE Inline Adapter, page 4-3
•
•
Replacing a Hard Disk Drive, page 4-6
Installing Memory, page 4-8
•
Before working on a system that has an on/off switch, turn OFF the power and
unplug the power cord. Statement 1
To reduce the risk of personal injury from hot surfaces, allow the drives and the
internal system components to cool before touching them.
Cisco Wide Area Virtualization Engine 574 Hardware Installation Guide
C H A P T E R
4
4-1
Advertisement
Table of Contents
Troubleshooting
Need help?
Do you have a question about the WAVE-574-K9 - Wide Area Virtualization Engine 574 and is the answer not in the manual?