Chapter Preparing To Install The Wave-574; Safety Warnings And Cautions - Cisco WAVE-574-K9 - Wide Area Virtualization Engine 574 Hardware Installation Manual

Safety Warnings and Cautions

Safety Warnings and Cautions
Warning
Warning
Warning
Warning
Warning
Warning
Caution
Cisco Wide Area Virtualization Engine 574 Hardware Installation Guide
2-2
Before you install the WAVE-574, observe the following safety warnings and
cautions:
Read the installation instructions before connecting the system to the power
source. Statement 1004
This unit is intended for installation in restricted access areas. A restricted
access area can be accessed only through the use of a special tool, lock and
key, or other means of security. Statement 1017
The plug-socket combination must be accessible at all times, because it serves
as the main disconnecting device. Statement 1019
This equipment must be grounded. Never defeat the ground conductor or
operate the equipment in the absence of a suitably installed ground conductor.
Contact the appropriate electrical inspection authority or an electrician if you
are uncertain that suitable grounding is available. Statement 1024
Only trained and qualified personnel should be allowed to install, replace, or
service this equipment. Statement 1030
Installation of the equipment must comply with local and national electrical
codes. Statement 1074
To properly ventilate the system, you must provide at least 7.6 cm (3.0 in) of
clearance at the front and back of the WAVE appliance.
Chapter 2 Preparing to Install the WAVE-574
OL-17738-01