Cisco WAVE-574-K9 - Wide Area Virtualization Engine 574 Hardware Installation Manual page 91

Chapter 6 Troubleshooting the System Hardware
Unsupported PCI Card Detected Remove PCI Card from Slot
Unsupported Processor Detected System will ONLY boot ROMPAQ Utility. System Halted.
WARNING: A Type 2 Header PCI Device Has Been Detected...
The BIOS will not configure this card. It must be configured properly by the OS or driver.
WARNING - Mixed Stepping Processors were detected. System cannot proceed.
301-Keyboard Error
Step 1
OL-17738-01
Action: Be sure the memory is installed correctly. Use only Cisco DIMM pairs
when populating memory sockets. See the
page 4-8. If the problem persists, contact the Cisco Technical Assistance Center.
Possible cause: The PCI card installed in the slot referenced in the message is
strictly not supported on this system.
Action: Remove the card from the slot reported in the message.
Possible Cause: Processor and/or processor stepping is not supported by the
current system ROM.
Action: If the problem persists, contact the Cisco Technical Assistance Center.
Possible Cause: Only Type 0 and Type 1 Header PCI Devices are configured by
the system ROM. The device will not work unless the OS or device driver properly
configure the card. Typically this message only occurs when PCI cards with a PCI
to PCMCIA bridge are installed.
Action: Check the installation of any PCI devices. If the problem persists, contact
the Cisco Technical Assistance Center.
Possible cause: One or more 800-MHz front side bus speed processors have been
initialized at 667-MHz.
Action: If the problem persists, contact the Cisco Technical Assistance Center.
Possible Cause: Keyboard failure occurred.
Action: To correct this failure, follow these steps:
Power down the WAVE appliance, and then reconnect the keyboard.
Cisco Wide Area Virtualization Engine 574 Hardware Installation Guide
Power-On Self Test (POST)
"Installing Memory" section on
6-21