Cisco WAVE-574-K9 - Wide Area Virtualization Engine 574 Hardware Installation Manual page 58

Installing Memory
Figure 4-5
Check to make sure that the DIMM latches are fully engaged in the notches.
Step 7
Install the access panel.
Step 8
Install the WAVE appliance into the rack.
Step 9
Step 10 Reboot the WAVE appliance.
Use the show memory EXEC mode command to verify that the memory you
Step 11
installed is recognized by the WAVE appliance.
Repartition the disks, using the disk delete-data-partitions command, and
Step 12
reload.
Note
Cisco Wide Area Virtualization Engine 574 Hardware Installation Guide
4-10
Installing a DIMM
Repartitioning the disks is required after adding memory to reset the DRE
space allocation.
Chapter 4 Installing Hardware Options for the WAVE-574
OL-17738-01