Table of Contents
Advertisement
Chapter 2
Preparing to Install the WAVE-574
Understanding the Environmental Requirements
Understanding the Power Requirements
Warning
OL-17738-01
Handle all sensitive components in a static-safe area. If possible, use
•
antistatic floor pads and workbench pads.
Handle the appliance carefully, holding it by its edges or its frame.
•
Do not touch solder joints, pins, or exposed printed circuitry.
•
Do not leave the appliance where others can handle and possibly damage the
•
appliance.
Take additional care when handling appliances during cold weather, because
•
heating reduces indoor humidity and increases static electricity.
To ensure continued safe and reliable equipment operation, install or position the
system in a well-ventilated, climate-controlled environment.
The maximum recommended ambient operating temperature (TMRA) for most
server products is 35 °C (95 °F). The temperature in the room where the rack is
located must not exceed 35 °C (95 °F).
For details about the WAVE-574 environmental requirements, see
"WAVE-574 Hardware Specifications."
Installation of this equipment must comply with local and regional electrical
regulations governing the installation of information technology equipment by
licensed electricians. This equipment is designed to operate in installations
covered by NFPA 70, 1999 Edition (National Electric Code) and NFPA-75, 1992
(code for Protection of Electronic Computer/Data Processing Equipment).
Take care when connecting units to the supply circuit so that wiring is not
overloaded. Statement 1018
Cisco Wide Area Virtualization Engine 574 Hardware Installation Guide
Understanding the Environmental Requirements
Appendix A,
2-7
Advertisement
Table of Contents
Troubleshooting
Need help?
Do you have a question about the WAVE-574-K9 - Wide Area Virtualization Engine 574 and is the answer not in the manual?