Cisco WAVE-574-K9 - Wide Area Virtualization Engine 574 Hardware Installation Manual page 87

Chapter 6 Troubleshooting the System Hardware
Illegal Opcode - System Halted
iLO Generated NMI
Internal CPU Check - Processor
Invalid memory types were found on the same node. Please check DIMM compatibility. - Some DIMMs
may not be used
Invalid Password - System Halted!
Invalid Password - System Restricted!
OL-17738-01
Action: Adjust the ambient temperature and check fans. If the problem persists,
contact the Cisco Technical Assistance Center.
Possible Cause: The WAVE appliance has entered the Illegal Operator Handler
because of an unexpected event. This error is often software-related and does not
necessarily indicate a hardware issue.
Action: Be sure that all software is installed properly. If the problem persists,
contact the Cisco Technical Assistance Center.
Possible Cause: The iLO controller generated an NMI.
Action: If the problem persists, contact the Cisco Technical Assistance Center.
Possible Cause: A processor has experienced an internal error.
Action: If the problem persists, contact the Cisco Technical Assistance Center.
Description: Invalid or mixed memory types were detected during POST.
Action: Use only Cisco DIMM pairs when populating memory sockets. See the
"Installing Memory" section on page
Cisco Technical Assistance Center.
Possible Cause: An invalid password was entered.
Action: Enter a valid password to access the system.
Possible Cause: A valid password that does not have permissions to access the
system has been entered.
Cisco Wide Area Virtualization Engine 574 Hardware Installation Guide
Power-On Self Test (POST)
4-8. If the problem persists, contact the
6-17