Cisco WAVE-574-K9 - Wide Area Virtualization Engine 574 Hardware Installation Manual page 90

Power-On Self Test (POST)
REDUNDANT ROM ERROR: Bootblock Invalid. - ...
...contact Your Representative.
REDUNDANT ROM ERROR: Primary ROM invalid. Booting Backup ROM. -...
...run ROMPAQ to correct error condition
Temperature violation detected - system Shutting Down in x seconds
There must be a first DIMM in pair if second DIMM in pair is populated. Second DIMM in pair ignored.
This system only supports 667 MHz Front Side Bus Speed Processors. One or more 800 MHz Front Side Bus
Speed Processors have been initialized at 667 MHz. System Halted!
Unsupported DIMM(s) found in system. - DIMM(s) may not be used
Cisco Wide Area Virtualization Engine 574 Hardware Installation Guide
6-20
Possible Cause: ROM bootblock is corrupt.
Action: If the problem persists, contact the Cisco Technical Assistance Center.
Possible Cause: The primary system ROM is corrupt. The system is booting from
the redundant ROM.
Action: If the problem persists, contact the Cisco Technical Assistance Center.
Possible Cause: The system has reached a cautionary temperature level and is
shutting down in X seconds.
Action: Adjust the ambient temperature and check the fans. If the problem
persists, contact the Cisco Technical Assistance Center.
Description: The first DIMM socket in the pair is not populated. The second
DIMM in the pair is not recognized or used.
Action: Be sure the memory is installed correctly. Use only Cisco DIMM pairs
when populating memory sockets. See the
page 4-8. If the problem persists, contact the Cisco Technical Assistance Center.
Possible cause: One or more 800-MHz front side bus speed processors have been
initialized at 667-MHz.
Action: If the problem persists, contact the Cisco Technical Assistance Center.
Description: Unsupported memory types found in system.
Chapter 6 Troubleshooting the System Hardware
"Installing Memory" section on
OL-17738-01