Configuration Example for LISP Multicast
Step 10
Step 11
Step 12
Step 13
Step 14
Step 15
Configuration Example for LISP Multicast
Example: Configuring LISP Multicast
The following example shows how to configure Locator/ID Separation Protocol (LISP) Multicast on either
the Egress Tunnel Router (ETR) or the Ingress Tunnel Router (ITR):
Cisco Nexus 7000 Series NX-OS LISP Configuration Guide
90
Command or Action
ip lisp etr map-server map-server-address
key key-type authentication-key
Example:
Device(config-vrf)# ip lisp etr
map-server 10.0.0.2 key 3
5b0f2bd760fe4ce3
ip lisp multicast
Example:
Device(config-vrf)# ip lisp multicast
exit
Example:
Device(config-vrf)# exit
show ipmroutedetail
Example:
Device# show ip mroute detail
show ippimlisp encap
Example:
Router# show ip pim lisp encap
show forwardingdistributionmulticast route
group-addr
Example:
Router# show forwarding distribution
multicast route group 226.1.1.1
Configuring LISP Multicast
Purpose
Configures the IPv4 locator address of the
Locator/ID Separation Protocol (LISP)
Map-Server to be used by the egress tunnel
router (ETR) when registering for IPv4 EIDs.
Up to two map servers may be
Note
configured if multiple map servers
are available. (See the LISP
Command Reference for more
details.)
Configures the device to support Locator/ID
Separation Protocol (LISP) Multicast
functionality.
Exits vrf configuration mode.
(Optional) Displays information about the
LISP multicast encapsulation for the IPv4
multicast routes.
(Optional) Displays information about the
LISP encapsulation indices stored by PIM.
(Optional) Displays information about the
multicast Forwarding Information Base (FIB)
distribution routes.