Configuring ITD
acl1
Node
------------------- ------- --- ---- ----- --------------- -- --- -------
1
Node
------------------- ------- --- ---- ----- --------------- -- --- -------
2
Node
------------------- ------- --- ---- ----- --------------- -- --- -------
3
test_itd_bucket_3
Node
------------------- ------- --- ---- ----- --------------- -- --- -------
4
switch(config)# sh run rpm
Configuration Example: One-Arm Deployment Mode
The configuration below uses the topology in the following figure:
IP
Cfg-S
WGT Probe Port
1.1.1.1
Active
Bucket List
--------------------------------------------------------------------------
test_itd_bucket_1
IP
Cfg-S
2.1.1.1
Active
Bucket List
--------------------------------------------------------------------------
test_itd_bucket_2
IP
Cfg-S
3.1.1.1
Active
Bucket List
--------------------------------------------------------------------------
IP
Cfg-S
4.1.1.1
Active
Bucket List
--------------------------------------------------------------------------
test_itd_bucket_4
Cisco Nexus 9000 Series NX-OS Intelligent Traffic Director Configuration Guide, Release 9.x
Configuration Example: One-Arm Deployment Mode
Probe-IP
1 ICMP
WGT Probe Port
Probe-IP
1 ICMP
WGT Probe Port
Probe-IP
1 ICMP
WGT Probe Port
Probe-IP
1 ICMP
STS Trk# Sla_id
OK
3
10003
STS Trk# Sla_id
OK
4
10004
STS Trk# Sla_id
OK
5
10005
STS Trk# Sla_id
OK
6
10006
43