Physical Dimensions; Led Definitions; Port Leds - Dell PowerConnect 5424 User Manual

If both RJ-45 and SFP are present, and a connector is inserted in the SFP port, the SFP port is active,
unless the copper connector of the Base-T port of the same number is inserted and has a link.
The system can switch from the RJ-45 to the SFP (or vice-versa) without a system reboot or reset.

Physical Dimensions

The device has the following physical dimensions:
• Height — 44 mm (1.73 inch)
• Width — 440 mm (17.32 inch)
• Depth — 255 mm (10.03 inch)

LED Definitions

The front panel contains light emitting diodes (LED) that indicate the status of links, power supplies,
fans, and system diagnostics.

Port LEDs

10/100/1000 Base-T Port LEDs
Each 10/100/1000 Base-T port has two LEDs. Speed/link/activity is indicated on the left LED and the
duplex mode is indicated on the right LED.
Figure 2-4. RJ-45 Copper based 10/100/1000 BaseT LEDs
The RJ-45 LED indications are described in the following table:
Table 2-1. RJ-45 Copper based 10/100/1000BaseT LED Indications
LED Color
Left LED Green Static
Green Flashing
Orange Static
Orange Flashing
Right LED Green
OFF
Description
The port is linked at 1000 Mbps.
The port is transmitting or receiving data at 1000 Mbps.
The port is linked at either 10 or 100 Mbps.
The port is transmitting or receiving data at either 10 or 100 Mbps.
The port is currently transmitting in Full Duplex mode.
The port is operating in Half Duplex mode.
Hardware Description
27