Dell PowerConnect 5424 User Manual page 294

5 Define the Type field.
6 Click Apply Changes.
The new source port is defined, and the device is updated.
Deleting a Copy Port from a Port Mirroring Session
1 Open the Port Mirroring page.
2 Select the Remove check box.
3 Click Apply Changes.
The selected port mirroring session is deleted, and the device is updated.
Configuring a Port Mirroring Session Using CLI Commands
The following table summarizes the equivalent CLI commands for configuring a Port Mirroring session
as displayed in the Port Mirroring page.
Table 7-15. Port Mirroring CLI Commands
CLI Command
port monitor src-interface [rx | tx]
The following is an example of the CLI commands:
Console(config)# interface ethernet g1
Console(config-if)# port monitor g8
Console# show ports monitor
Source Port Destination Port
----------- ----------------
g8 g1
g2 g8
g18 g8
294
Configuring Device Information
Description
Starts a port monitoring session.
Type
------------
RX, TX
RX, TX
Rx
Status VLAN Tagging
------- ------------
Active No
Active No
Active No