Dell PowerConnect 5424 User Manual page 185

• Management IP Address — Indicates the management IP address that is advertised from the
interface.
• Use Default — Indicates that information included in the TLVs is per the device defaults.
The possible field values are:
– Checked — Enables sending the device default LLDP advertisements.
– Unchecked — Indicates that the device LLDP advertisement settings are disabled, and LLDP
advertisement settings are user defined. This is the default value.
The LLDP Port Table page displays the LLDP Port Configuration. To open the LLDP Port Table,
→
click Security LLDP
Figure 6-72. LLDP Port Table
Table 6-40. LLDP Port settings CLI Commands
CLI Command
clear lldp rx interface
lldp optional-tlv tlv1 [tlv2
... tlv5]
lldp enable [rx | tx | both] To enable Link Layer Discovery
The following is an example of the CLI commands:
Console(config)# interface ethernet g5
Console(config-if)# lldp enable
→ →
Port Settings Show All in the tree view.
Description
Restarts the LLDP RX state machine
and clearing the neighbors table
Specifies which optional TLVs from the
basic set should be transmitted
Protocol (LLDP) on an interface.
Configuring System Information
185