Dell PowerConnect 5424 User Manual page 133

When defining a new DNS server, the following additional parameters are available:
• Supported IP Format — Specifies the IP format supported by the server. The possible values are:
– IPv6 — IP version 6 is supported.
– IPv4 — IP version 4 is supported.
• IPv6 Address Type — When the server supports IPv6 (see previous parameter), this specifies the type
of static address supported. The possible values are:
– Link Local — A Link Local address that is non-routable and used for communication on the same
network only.
– Global — A globally unique IPv6 address; visible and reachable from different subnets.
• Link Local Interface — When the server supports an IPv6 Link Local address (see previous
parameter), this specifies the the Link Local interface. The possible values are:
– VLAN1 — The IPv6 interface is configured on VLAN1.
– ISATAP — The IPv6 interface is configured on ISATAP tunnel.
Adding a DNS Server
1 Open the Domain Naming System (DNS) page.
2 Click Add.
The Add DNS Server page opens:
Figure 6-38. Add DNS Server
3 Define the relevant fields.
4 Click Apply Changes.
The new DNS server is defined, and the device is updated.
Configuring System Information
133