Defining Ipv6 Neighbors - Dell PowerConnect 5424 User Manual

Defining IPv6 ISATAP Tunnel Parameters Using CLI Commands
The following table summarizes the equivalent CLI commands for setting fields displayed in the IPv6
ISATAP Tunnel page.
Table 6-21. IPv6 Default Gateway CLI Commands
CLI Command
interface tunnel number
tunnel mode ipv6ip {isatap}
tunnel isatap router router_name
tunnel source { auto | ip-address ipv4-
address | interface }
tunnel isatap query-interval seconds
tunnel isatap solicitation-interval
seconds
tunnel isatap robustness number
show ipv6 tunnel
The following is an example of the CLI commands:
Console> show ipv6 tunnel
Router DNS name: ISATAP
Router IPv4 address: 172.16.1.1
DNS Query interval: 10 seconds
Min DNS Query interval: 0 seconds
Router Solicitation interval: 10 seconds
Min Router Solicitation interval: 0 seconds
Robustness: 3

Defining IPv6 Neighbors

The IPv6 Neighbors Page contains information for defining IPv6 Neighbors which is similar to the
functionality of the IPv4 Address Resolution Protocol (ARP). IPv6 Neighbors enables detecting Link Local
addresses within the same subnet, and includes a database for maintaining reachability information
about the active neighbors paths.
Description
Enters tunnel interface configuration mode.
Configures an IPv6 transition mechanism global support mode.
Configures a global string that represents a specific automatic tunnel
router domain name.
Sets the local (source) IPv4 address of a tunnel interface.
Configures the interval between DNS Queries (before the IP address of
the ISATAP router is known) for the automatic tunnel router domain
name.
Configures the interval between ISATAP router solicitations messages
(when there is no active ISATAP router).
Configure the number of DNS Query / Router Solicitation refresh
messages that the device sends.
Displays information on the ISATAP tunnel.
Configuring System Information
125