To open the IPv6 Default Gateway page, click System
tree view.
Figure 6-30. IPv6 Default Gateway
•
Default Gateway IP Address — Displays the Link Local IPv6 address of the default gateway.
•
Interface — Specifies the outgoing interface through which the default gateway can be reached.
Interface refers to any Port/LAG/VLAN and/or Tunnel.
•
Type — Specifies the means by which the default gateway was configured. The possible field
values are:
–
Static — Indicates the default gateway is user-defined.
–
Dynamic — Indicates the default gateway is dynamically configured.
•
State — Displays the default gateway status. The possible field values are:
–
Incomplete — Indicates that address resolution is in progress and the link-layer address of the
default gateway has not yet been determined.
–
Reachable — Indicates that the default gateway is known to have been reachable recently
(within tens of seconds ago).
–
Stale — Indicates that the default gateway is no longer known to be reachable but until traffic is
sent to the default gateway, no attempt is made to verify its reachability.
→
→
IP Addressing
IPv6 Default Gateway in the
Configuring System Information
121