Expansion Slots; Internal Hot Plug Drive Bays; Internal Removable Media Drive Bays; Information On - Compaq ProLiant 6000 Series Setup And Installation Manual

Expansion Slots

Ten I/O expansion slots and three 33-MHz PCI
Five 64-bit PCI slots (PCI Bus 3)
Four 32-bit PCI slots (PCI Buses 1 and 2)
One ISA modem slot
IMPORTANT: Slot 1 of the I/O board is dedicated to ISA Modem support.
Only install an ISA Modem into Slot 1 of the I/O board.

Internal Hot Plug Drive Bays

Supports up to three hard-drive cages that can be configured with six 1-
inch hot-plug hard drives, four 1.6-inch hot-plug hard drives, or a
combination of both 1-inch and 1.6-inch drives. Drives may be of any
supported storage capacity, but must be mounted on Compaq hot-plug
drive trays.
Each cage is capable of supporting a maximum of six 1-inch hot-plug
drives (totaling eighteen drives with all three drive cages installed) or
four 1.6-inch hot-plug drives (totaling twelve drives with all three drive
cages installed).
For a list of supported drive storage capacities, see the ProLiant 6000
information on the Compaq website, www.compaq.com.

Internal Removable Media Drive Bays

Supports six non-hot-plug removable media drive bays:
For use with Pentium II Xeon and Pentium III Xeon processor-based servers only
One third-height drive bay occupied by 1.44-MB diskette drive
One half-height drive bay occupied by an IDE CD-ROM drive
Four half-height 5.25-inch drive bays
Compaq ProLiant 6000 Setup and Installation Guide
1-3