Turning The Snmp Agent On Or Off; Configuring Trap Recipients; Add Trap Recipient Dialog Box; Snmp Agent Setup Dialog Box - HP 316095-B21 - StorageWorks Edge Switch 2/24 User Manual

Figure 31 shows the dialog box used to configure the SNMP agent.
Figure 31

SNMP Agent Setup dialog box

Turning the SNMP agent on or off

To turn the SNMP agent on or off, select Monitor > SNMP Agent > On | Off from the HAFM
menu bar.

Configuring trap recipients

To configure the SNMP agent that runs on the appliance and implements the Fibre Alliance MIB,
perform the following:
1. Select Monitor > SNMP Agent > Setup from the HAFM menu bar.
The SNMP Agent Setup dialog box opens
Click the Trap Recipients tab.
2.
3. Select Enable Authorization Traps if you want to enable messages to be sent when
unauthorized management stations try to access SNMP information through the appliance.
Click Add.
4.
The Add Trap Recipient dialog box opens
Figure 32

Add Trap Recipient dialog box

5. If you want this trap recipient to be active, select the Activate check box.
6. Enter the IP address or DNS host name of the trap recipient in the IP Address box.
This name must be 64 characters or fewer.
68 Managing the HAFM application
(Figure 31).
(Figure 32).