HP 316095-B21 - StorageWorks Edge Switch 2/24 User Manual page 221

Table 24 Element Manager Messages (continued)
Message
Switch clock alert mode
must be cleared before
enabling period
synchronization.
The data collection
process failed.
The data collection
process has been
aborted.
The default zone must be
disabled to configure.
The Ethernet link
dropped.
The firmware file is
corrupted.
The firmware version
already exists.
The following parameters
cannot be disabled while
Enterprise Fabric Mode is
active: Insistent Domain
ID, Rerouting Delay,
Domain RSCNs.
Description
Clock alert mode is
enabled through the
Configure FICON
Management Server
dialog box and user is
attempting to enable
Periodic Date/Time
Synchronization through
the Configure Date and
Time dialog box.
An error occurred while
performing the data
collection procedure.
You aborted the data
collection procedure.
The message displays
when you attempted to
change the management
style to Open Fabric and
the default zone is
enabled.
The Ethernet connection
between the HAFM
appliance and the
director is down or
unavailable.
A firmware version file is
corrupt.
This firmware version
already exists in HAFM
appliance's firmware
library.
You attempted to disable
these parameters in the
Configure Switch
Parameters dialog box
while Enterprise Fabric
Mode is enabled.
Action
Disable clock alert mode through
the Configure FICON
Management Server dialog box.
Try the data collection procedure
again. If the problem persists,
contact the next level of support.
Verify the data collection
procedure is to be aborted, then
click OK to continue.
Disable the default zone and
repeat the operation.
Establish and verify the network
connection.
Contact the next level of support to
report the problem.
Informational message only—no
action is required.
Disable Enterprise Fabric Mode
through the Enterprise Fabric
Mode dialog box in HAFM, then
disable the parameters.
HA-Fabric Manager user guide 221