HP 316095-B21 - StorageWorks Edge Switch 2/24 User Manual page 187

Table 23 HAFM Messages (continued)
Message
Cannot modify product.
Cannot perform
operation. Fabric is
unknown.
Cannot perform
operation. The list of
attached nodes is
unavailable.
Cannot retrieve current
SNMP configuration.
Cannot save current
SNMP configuration.
Cannot set write
authorization without
defining a community
name.
Cannot show zoning
library. No fabric exists.
Click OK to remove all
contents from log.
Description
The selected product
cannot be modified.
This message displays if
no switches in the fabric
are connected to the
HAFM appliance.
This message displays
when attached nodes are
unavailable and you
attempt to modify a zone
or create a new zone.
The current SNMP
configuration could not
be retrieved.
The current SNMP
configuration could not
be saved.
An SNMP community
name has not been
configured.
You cannot show the
zoning library if no fabric
exists. You must have
identified a switch or
director to the HAFM
application for a fabric to
exist.
This action deletes all
contents from the selected
log.
Action
Verify the HAFM
appliance-to-product link is up. If
the link is up:
• The HAFM appliance may
be busy.
• Another Element Manager
instance may be open.
• You may not have
permission to modify the
product.
Ensure at least one fabric-attached
switch or director has an Ethernet
connection to the HAFM appliance
and retry the operation.
Verify an attached node is
available and retry the operation.
Try again. If the problem persists,
contact the next level of support.
Try again. If the problem persists,
contact the next level of support.
Enter a valid community name in
the Configure SNMP dialog box.
Identify an existing switch or
director to the HAFM application
using the New Product dialog box.
Click OK to delete the log contents
or Cancel to cancel the operation.
HA-Fabric Manager user guide 187