HP 316095-B21 - StorageWorks Edge Switch 2/24 User Manual page 218

Table 24 Element Manager Messages (continued)
Message
Not all of the optical
transceivers are installed
for this range of ports.
Open Trunking is not
installed for this product.
Please contact your sales
representative.
Performing this operation
will change the current
state to Offline.
Performing this operation
will change the current
state to Online.
Performing this action will
overwrite the date/time
on the switch.
Periodic Date/Time
synchronization must be
cleared.
Port binding was
removed from attached
devices that are also
participating in Switch
Binding.
Port cannot swap to itself.
218 Informational and error messages
Description
Some ports in the
specified range do not
have optical transceivers
installed.
The Open Trunking
feature key has not been
enabled. This message
only displays if the
optional Open Trunking
feature is installed.
This message requests
confirmation to set the
director offline.
This message requests
confirmation to set the
director online.
Warning that occurs
when configuring the
date and time through the
Configure Date and Time
dialog box, that the new
time or date will
overwrite the existing
time or date set for the
director or switch.
Action cannot be
performed because
Periodic Date/Time
Synchronization option is
active.
Informational message.
You removed Port
Binding from attached
devices, but one or more
of these devices is still
controlled by Fabric
Binding.
Port addresses entered in
the Swap Ports dialog
box are the same.
Action
Use a port range that is valid for
the ports installed.
Enter the feature key into the
Configure Feature Key dialog box
and enable the key. If you require
a feature key, see your account
representative.
Click OK to set the director offline
or click Cancel to cancel the
operation.
Click OK to set the director online
or click Cancel to cancel the
operation.
Verify that you want to overwrite
the current date or time.
Click Periodic Date/Time
Synchronization check box in
Configure Date and Time dialog
box (Configure menu) to clear
check mark and disable periodic
date/time synchronization.
Review the Switch Binding
Membership List to determine if the
devices should be members.
Ensure that address in the first and
second Port Address fields are
different.