HP 316095-B21 - StorageWorks Edge Switch 2/24 User Manual page 217

Table 24 Element Manager Messages (continued)
Message
Log is currently in use.
Loopback plug(s) must be
installed on ports being
diagnosed. Press Next to
continue.
Maximum number of
versions already
installed.
No file was selected.
No firmware version file
was selected.
No firmware versions to
delete.
Nonredundant director
must be offline to install
firmware.
Description
Access to the log is
denied because the log
was opened by another
instance of the Element
Manager.
External loopback
diagnostics require an
optical loopback plug to
be installed.
The number of firmware
versions that can be
defined to the HAFM
application's firmware
library (eight) was
reached.
Action requires the
selection of a file.
A file was not selected in
the Firmware Library
dialog box before an
action, such as modify or
send was performed.
There are no firmware
versions in the firmware
library to delete,
therefore the operation
cannot be performed.
For directors, if the
director has only one CTP
card, the director must be
set offline to install a
firmware version.
For switches, since the
switch has only a single
CTP card, it must be
offline to initiate a
firmware installation.
Note that the CTP card is
an internal component
and not a FRU.
Action
Retry the operation later. If the
condition persists, contact the next
level of support.
Ensure that an optical loopback
plug is installed in port optical
transceiver before running external
wrap diagnostic testing.
Delete an existing firmware version
before adding a new version.
Select a file.
Click on a firmware version in the
dialog box to select it, then
perform the action again.
Informational message only—no
action is required.
Set the director or switch offline
and install the firmware.
HA-Fabric Manager user guide 217