HP 316095-B21 - StorageWorks Edge Switch 2/24 User Manual page 219

Table 24 Element Manager Messages (continued)
Message
Port diagnostics cannot
be performed on an
inactive port.
Port speeds cannot be
configured at a higher
rate than the director
speed.
Port numbers must be in
the range of 0 to xxx.
Preferred Paths can not
be enabled until the
Domain ID is set to
Insistent. Disable
Preferred Paths, then
configure Switch
Parameters.
R_A_TOV must be
greater than E_D_TOV.
Resource is unavailable.
Resource is unavailable.
SANtegrity Feature not
installed. Please contact
your sales representative.
Send firmware failed.
Description
This displays when port
diagnostics is run on a
port in an inactive state.
This displays when you
configure a port to 2
Gb/sec and the director
speed is set to 1 Gb/sec.
When configuring
Preferred Paths, source
ports and exit ports must
be in the range of ports
for the switch being
configured.
If the switch's domain ID
has not been set to
Insistent, the user is not
allowed to activate the
Preferred Path
configuration with the
Enable Preferred Paths
check box selected.
R_A_TOV must be
greater than E_D_TOV.
The specified operation
cannot be performed
because the product is
unavailable.
The specified operation
cannot be performed
because the product is
unavailable.
You selected Switch
Binding from the
Configure menu, but the
optional SANtegrity
Binding feature is not
installed.
A firmware download
operation failed.
Action
Run the diagnostics on an active
port.
Set the director speed to 2 Gb/sec
in the Configure Switch Parameter
dialog box.
In the Configure Preferred Paths
dialog box, change the numbers in
the Source Port and Exit Port fields
to fall within the port count of the
switch on which you are
configuring paths.
Close the Configure Preferred
Paths dialog box and click
Configure > Operating Parameters
> Switch Parameters. In the
Configure Switch Parameters
dialog box, click the Insistent
check box.
Change one of the values so that
R_A_TOV is greater than E_D_TOV
Verify that the Ethernet connection
between the HAFM appliance and
the director is up or available.
Verify that the HAFM
appliance-to-product link is up. If
the link is up, the HAFM appliance
may be busy. Try the operation
again later.
Install the SANtegrity Binding key
through the Configure Feature Key
dialog box before using Switch
Binding features.
Retry the firmware download
operation. If the problem persists,
contact the next level of support.
HA-Fabric Manager user guide 219