HP 316095-B21 - StorageWorks Edge Switch 2/24 User Manual page 209

Table 24 Element Manager Messages (continued)
Message
Could not stop port
diagnostics.
Could not write firmware
to flash.
Control Unit Port (CUP)
name and port name are
identical (FICON ONLY).
Date entered is invalid.
Device applications
should be terminated
before starting
diagnostics. Press NEXT
to continue.
[device WWN] cannot
be removed from the
Switch Membership List
while participating in
Switch Binding. The
device must be isolated
from the switch, or Switch
Binding deactivated
before it can be removed.
Description
Port diagnostics could not
be stopped by the
Element Manager
because the Ethernet link
is down or busy, or
because the director is
busy.
A firmware version could
not be written from the
HAFM appliance to
FLASH memory
Within the address
configuration, one or
more of the port names
are the same as the CUP
name.
The date is entered
incorrectly in the
Configure Date and Time
dialog box. Individual
field entries may be
correct, but the overall
date is invalid (for
example, a day entry of
31 for a 30-day month).
Port diagnostics
(loopback tests) cannot
be performed on a port
while an attached device
application is running.
You attempted to remove
a device WWN from the
Switch Membership List
(SANtegrity Binding
feature) while Switch
Binding is enabled.
Action
Retry the operation later. If the
condition persists, contact the next
level of support.
Retry the operation again. If the
condition persists, contact the next
level of support.
Make sure all names are unique
for the ports and CUP name.
Verify each entry is valid and
consistent.
Terminate the device application
and perform diagnostics again.
Remove the device from the switch
by blocking the port, setting the
switch offline, or disabling Switch
Binding through the Switch Binding
Change State dialog box before
removing devices from the Switch
Membership List.
HA-Fabric Manager user guide 209