HP 316095-B21 - StorageWorks Edge Switch 2/24 User Manual page 220

Table 24 Element Manager Messages (continued)
Message
SNMP trap address not
defined.
Stop diagnostics failed.
The test is already
running.
Stop diagnostics failed.
The test was not running.
Switch Binding was
removed from attached
devices that are also
participating in Port
Binding. Please review
the Port Binding
Configuration.
System diagnostics
cannot run. The
Operational Status is
invalid.
The add firmware
process has been
aborted.
220 Informational and error messages
Description
If an SNMP community
name is defined, a
corresponding SNMP
trap recipient address
must also be defined.
Diagnostics for the port
was not running and
Stop was selected on the
Port Diagnostics dialog
box. Diagnostics quit for
the port for some reason,
but the Stop button
remains enabled.
This action failed
because the test was not
running.
The device WWNs were
removed from the
director's Switch
Membership List
(SANtegrity Binding
feature), but you should
note that one or more of
these devices still has
security control in port
binding.
System diagnostics
cannot run on switches
with failed ports
You aborted the process
to add a firmware version
to the HAFM appliance's
firmware library.
Action
Enter a corresponding SNMP trap
recipient address.
Verify port operation. Retry
diagnostics for the port and
choose Stop from the dialog box.
If problem persists, contact the next
level of support.
Informational message.
Verify that the security level for
each device is as required by
reviewing the Bound WWN list in
the Configure Ports dialog box.
Replace failed ports.
Verify the firmware addition is to
be aborted, then click OK to
continue.