Diskette Drive Activity Light Does Not Light; Cd-Rom Drive Or Dvd-Rom Drive Activity Light Does Not Light; Cannot Connect To A Server - Intel SR1325TP1 - Entry Server Platform User Manual

Troubleshooting

Diskette Drive Activity Light Does Not Light

Check the following:
Are the diskette drive's power and signal cables properly installed?
Are all relevant switches and jumpers on the diskette drive set correctly?
Is the diskette drive properly configured?
Is the diskette drive activity light always on? If so, the signal cable may be plugged in
incorrectly.
If you are using the onboard diskette controller, use the BIOS setup to make sure that "Onboard
Floppy" is set to "Enabled." If you are using an add-in diskette controller, make sure that
"Onboard Floppy" is set to "Disabled."

CD-ROM Drive or DVD-ROM Drive Activity Light Does Not Light

Check the following:
Are the CD-ROM/DVD-ROM drive's power and signal cables properly installed?
Are all relevant switches and jumpers on the drive set correctly?
Is the drive properly configured?

Cannot Connect to a Server

Make sure the network cable is securely attached to the correct connector at the system back
panel.
Try a different network cable.
Make sure you are using the correct and the current drivers. See
Software" for a link to the current drivers.
Make sure the driver is loaded and the protocols are bound.
Make sure the hub port is configured for the same duplex mode as the network controller.
Make sure the correct networking software is installed.
If you are directly connecting two servers (without a hub), you will need a crossover cable.
Check the network controller LEDs next to the NIC connectors.
68
"Additional Information and
®
Intel Entry Server Platform SR1325TP1-E User Guide