Chapter 33 Working With System Software Images; Software Image Naming Conventions; Downloading System Software Images To The Switch Using Tftp - Cisco WS-C2948G-GE-TX Configuration Manual

Working with System Software Images
This chapter describes how to work with system software image files on the Catalyst enterprise LAN
switches.
Note For complete syntax and usage information for the commands that are used in this chapter, refer to the
Catalyst 4500 Series, Catalyst 2948G, Catalyst 2948G-GE-TX, and Catalyst 2980G Switches Command
Reference.
This chapter consists of these sections:
•
•
•
•
•
•

Software Image Naming Conventions

The software images on the Catalyst 4500 series switches use the following naming conventions.
Software release 6.1(3) is used in the examples:
•
•
•
Downloading System Software Images to the Switch
Using TFTP
The following sections describe how to download system software images to the switch supervisor
engine and to intelligent modules.
Catalyst 4500 Series, Catalyst 2948G, Catalyst 2948G-GE-TX, and Catalyst 2980G Switches Software Configuration Guide—Release 8.2GLX
78-15908-01
Software Image Naming Conventions, page 33-1
Downloading System Software Images to the Switch Using TFTP, page 33-1
Uploading System Software Images to a TFTP Server, page 33-4
Downloading System Software Images to the Switch Using rcp, page 33-5
Uploading System Software Images to an rcp Server, page 33-8
Upgrading the ROM Monitor, page 33-9
6.1(3) Flash image (standard)—cat4000.6-1-3.bin
6.1(3) Flash image (CiscoView)—cat4000-cv.6-1-3.bin
6.1(3) Flash image (Secure Shell)—cat4000-k9.6-1-3.bin
C H A P T E R
33
33-1