Vlan-Bridge Spanning Tree; Configuring Spanning-Tree Features; Default Spanning-Tree Configuration - Cisco Catalyst 3750 Software Configuration Manual

Metro switch
Hide thumbs Also See for Catalyst 3750:
Table of Contents

Advertisement

Chapter 14
Configuring STP

VLAN-Bridge Spanning Tree

Cisco VLAN-bridge spanning tree is used with the fallback bridging feature (bridge groups), which
forwards non-IP protocols such as DECnet between two or more VLAN bridge domains or routed ports.
The VLAN-bridge spanning tree allows the bridge groups to form a spanning tree on top of the individual
VLAN spanning trees to prevent loops from forming if there are multiple connections among VLANs.
It also prevents the individual spanning trees from the VLANs being bridged from collapsing into a
single spanning tree.
To support VLAN-bridge spanning tree, some of the spanning-tree timers are increased. To use the
fallback bridging feature, you must have the enhanced multilayer software image installed on your
switch. For more information, see

Configuring Spanning-Tree Features

These sections describe how to configure spanning-tree features:

Default Spanning-Tree Configuration

Table 14-3
Table 14-3 Default Spanning-Tree Configuration
Feature
Enable state
Spanning-tree mode
Switch priority
Spanning-tree port priority (configurable on a per-interface basis)
78-15870-01
shows the default spanning-tree configuration.
Chapter 33, "Configuring Fallback Bridging."
(required)
(optional)
(optional)
(optional)
(optional)
(optional)
(optional)
Default Setting
Enabled on VLAN 1.
For more information, see the
Spanning-Tree Instances" section on
page
PVST+. (Rapid PVST+ and MSTP are
disabled.)
32768.
128.
Catalyst 3750 Metro Switch Software Configuration Guide
Configuring Spanning-Tree Features
(optional)
14-10.
"Supported
14-11

Advertisement

Table of Contents
loading

Table of Contents