Configuring Periodic Re-Authentication - Cisco Catalyst 2960-X Security Configuration Manual

Configuring Periodic Re-Authentication

Command or Action
Step 4
end
Example:
Switch(config-if)# end
Configuring Periodic Re-Authentication
You can enable periodic 802.1x client re-authentication and specify how often it occurs. If you do not specify
a time period before enabling re-authentication, the number of seconds between attempts is 3600.
Beginning in privileged EXEC mode, follow these steps to enable periodic re-authentication of the client and
to configure the number of seconds between re-authentication attempts. This procedure is optional.
SUMMARY STEPS
1. configure terminal
2. interface interface-id
3. authentication periodic
4. authentication timer {{[inactivity | reauthenticate | restart]} {value}}
5. end
DETAILED STEPS
Command or Action
Step 1 configure terminal
Example:
Switch# configure terminal
Step 2 interface interface-id
Example:
Switch(config)# interface
gigabitethernet2/0/1
Catalyst 2960-X Switch Security Configuration Guide, Cisco IOS Release 15.0(2)EX
312
Purpose
You must configure the voice VLAN for the IP phone when
Note
the host mode is set to multi-domain.
Make sure that the authentication port-control interface configuration
command is set to auto for the specified interface.
Returns to privileged EXEC mode.
Purpose
Enters the global configuration mode.
Specifies the port to be configured, and enter interface configuration
mode.
Configuring IEEE 802.1x Port-Based Authentication
OL-29048-01