Verifying Installation; Security Options For Mac Os X; Configuring Wep Keys; Entering A New Wep Key - Cisco AIR-PCM340 Installation And Configuration Manual

Security Options for Mac OS X

Verifying Installation

To verify that you have properly installed the appropriate driver and client utilities, perform one of the
following:
•
If your installation was unsuccessful or you experienced problems during or after driver installation,
Note
refer to Chapter 8 for troubleshooting tips.
Security Options for Mac OS X

Configuring WEP Keys

The client utility allows you to enable or disable WEP and to create new WEP keys or use an existing key.
Note Entering a WEP key does not enable WEP.

Entering a New WEP Key

Follow the instructions below to enter a new WEP key for your client adapter. If you wish to select an
existing WEP key, go to the
If the client utility is not active on your desktop perform the following steps:
Step 1
a.
Figure 4-10 Finder Menu Bar
Cisco Aironet Wireless LAN Adapters Installation and Configuration Guide for Mac OS
4-12
Double-click the pcm3x0PPC icon in the Cisco pcm3x0 folder to open the pcm3x0PPC client
utility. If the installation was successful, the top of the Basic Properties screen indicates that your
client adapter is associated to an access point and provides its IP address.
"Selecting an Existing WEP Key" section on page
From the Finder menu bar on the top of the screen, select Go and click Applications (see
Figure 4-10). The applications screen appears.
Chapter 4 Security Features
4-14.
OL-1377-01