Verifying Installation - Cisco AIR-PCM352 - Aironet 350 Series 11Mbps Wireless LAN PC Card Adapter Installation And Configuration Manual

Chapter 3 Installing the Client Adapter
Insert the client adapter into the PC card slot of the Windows CE device. Refer to
Step 23
instructions on inserting the client adapter.
The Windows CE device should configure the client adapter, and the green LED on the adapter should
blink. If this does not happen, remove the client adapter, reset the Windows CE device, and reinsert the
client adapter.
The Cisco Wireless LAN Adapter Settings dialog box appears. If the dialog box does not appear, perform
Step 24
one of the following:
•
•
•
•
Step 25 Perform one of the following:
•
•
Step 26 The driver and client utility installation is complete. Go to the
determine if the installation was successful.

Verifying Installation

To verify that you have properly installed the driver and client utilities, check the client adapter's LEDs.
If the installation was successful, the client adapter's green LED blinks.
If your installation was unsuccessful or you experienced problems during or after driver installation,
Note
refer to
Now that your client adapter is properly installed, you are ready to go to
your client adapter unless your device is running Windows CE .NET. If your device is running Windows
CE .NET, go to the
on page
OL-1375-04
Tap Start > Settings > the Connections tab > Connections > Advanced > Network Card > Cisco
Wireless LAN Adapter on PPC 2003 devices.
Tap Start > Settings > the Connections tab > Network Adapters > Cisco Wireless LAN Adapter
> Properties on PPC 2002 devices.
Tap Start > Settings > Control Panel > Network > the Adapters tab > Cisco Wireless LAN
Adapter > Properties on HPC devices.
Tap Start > Settings > Network and Dial-up Connections > the Cisco Wireless LAN Client
Adapter icon on Windows CE .NET devices.
If your device is connected to a DHCP server, choose Obtain an IP address via DHCP or
Use server-assigned IP address and tap OK.
If your device is not connected to a DHCP server, choose Specify an IP address or Use specific IP
address and follow these steps:
a. Enter the IP address, subnet mask, and default gateway address you want to assign to your
device. They can be obtained from your system administrator.
b. Choose the Name Servers tab and enter the primary and secondary DNS and WINS you want
to assign to your device. They can be obtained from your system administrator.
c. Tap OK.
Chapter 9 for troubleshooting information.
"Deciding How to Configure Your Client Adapter (Windows CE .NET Only)" section
3-6.
Cisco Aironet 350 Series Wireless LAN Client Adapters Installation and Configuration Guide for Windows CE
Verifying Installation
Chapter 8
"Verifying Installation" section below to
Chapter 4 to create profiles for
for specific
3-5