Installing the Client Adapter
The Cisco Wireless LAN Adapter Settings dialog box appears. (If the dialog box does not appear, select
one of the following:
Perform one of the following:
The driver and client utility installation is complete. Go to the
determine if the installation was successful.
To verify that you have properly installed the driver and client utilities, check the client adapter's LEDs.
If the installation was successful, the client adapter's green LED blinks.
If your installation was unsuccessful or you experienced problems during or after driver installation,
Now that your client adapter is properly installed, you are ready to go to
your client adapter unless your device is running Windows CE .NET. If your device is running Windows
CE .NET, go to the
Start > Settings > the Connections tab > Network Adapters > Cisco Wireless LAN Adapter >
Properties on PPC devices,
Start > Settings > Control Panel > Network > the Adapters tab > Cisco Wireless LAN Adapter
> Properties on HPC devices, or
Start > Settings > Network and Dial-up Connections > the Cisco Wireless LAN Client Adapter
icon on Windows CE .NET devices.)
If your device is connected to a DHCP server, select Obtain an IP address via DHCP or
Use server-assigned IP address and tap OK.
If your device is not connected to a DHCP server, select Specify an IP address or Use specific IP
address and follow the steps below:
Enter the IP address, subnet mask, and default gateway address you want to assign to your
device. They can be obtained from your system administrator.
Select the Name Servers tab and enter the primary and secondary DNS and WINS you want to
assign to your device. They can be obtained from your system administrator.
for troubleshooting information.
"Deciding How to Configure Your Client Adapter (Windows CE .NET Only)"
Cisco Aironet Wireless LAN Client Adapters Installation and Configuration Guide for Windows CE
section below to
to create profiles for