Table of Contents
Advertisement
JUNOSe 11.1.x Physical Layer Configuration Guide
210
Monitoring Ethernet Interfaces
up Interface is enabled
down Interface is disabled
Hardware Type of MAC device on this interface
Address MAC address of the processor on this interface
MAU Type of medium attachment unit (MAU) on the primary and secondary
physical ports:
SFP 1000BASE-LH, 1000BASE-SX, 1000BASE-ZX; for SFPs that are
empty, SFP (Empty) appears in this field; for SFPs that are installed in
the OC3-2 GE APS I/O module and do not have a Juniper Networks part
number programmed, SFP (GE Compliant) appears in this field
XFP 10GBASE-SR (10 Gbps), 10GBASE-LR (10 Gbps), 10GBASE-ER
(10 Gbps); for XFPs that are empty, XFP (Empty) appears in this field
MTU Size of the MTU for this interface
Operational Size of the largest packet processed
Administrative Setting for MTU size that you specified
Duplex Mode Duplex option for this interface
Operational Duplex option currently used
Administrative Setting for duplex that you specified
Speed Line speed for this interface
Operational Current rate at which packets are processed
Administrative Setting for line speed that you specified
Debounce Debounce configuration for this interface
State is Enabled, Disabled
Interval is Number of seconds that this interface maintains a given
state before the state change is reported to the upper-layer links
Clear arp State of the removal of the ARP entries on an interface with
redundant ports
Enabled Clears ARP entries on the interface when the primary link
fails
Disabled Maintains ARP entries on the interface until the specified
timeout elapses
Link
Link information for this interface
Operational Link Selected Port that the I/O module is currently using:
primary or secondary
Administrative link selected Port that the I/O module is configured to
use:
Advertisement
Table of Contents
