Table of Contents
Advertisement
t1 fdl transmit
NOTE: The router sends FDL messages specified with "t1 fdl string" on page 18 only
if you have issued the t1 fdl command with the ansi or all keyword. If you specified
the att keyword with the t1 fdl command, the router sends only performance data.
t1 yellow detect
t1 yellow generate
Use the no version to restore the default value to the specified FDL message or
to all FDL messages.
See t1 fdl string.
Use to configure the router to send the specified type of FDL message.
By default, the router sends only FDL performance data messages.
Specify the keyword path-id to transmit path identifications every second.
Specify the keyword idle-signal to send idle signals every second.
Specify the keyword test-signal to transmit test signals every second.
Example
host1(config-controll)#t1 28 fdl transmit path-id
Use the no version to disable transmission of the specified FDL message or all
FDL messages.
See t1 fdl transmit.
Use to detect yellow alarm for T1 channels.
By default, T1 channels detect alarms.
Example
host1(config-controll)#t1 6,10-14,19 yellow detect
Use the no version to disable detection of yellow alarms.
See t1 yellow.
Use to generate a yellow alarm when a loss of frame or loss of signal condition
is detected on T1 channels.
By default, T1 channels generate alarms.
Example
host1(config-controll)#t1 6,10-14,19 yellow generate
Use the no version to disable generation of yellow alarms.
See t1 yellow.
Chapter 1: Configuring Channelized T3 Interfaces
Configuration Tasks
19
Advertisement
Table of Contents
