Juniper PHYSICAL LAYER - CONFIGURATION GUIDE V11.1.X Configuration Manual page 249

Junose software for broadband services routers
Table of Contents

Advertisement

max-interfaces
tunnel-server
Issue the no tunnel-server command from Global Configuration mode. This
command unprovisions the tunnel-service interfaces on the specified tunnel-server
port but does not delete the port itself.
host1(config)#no tunnel-server 2/2
Use from Tunnel Server Configuration mode to provision the maximum number
of tunnel-service interfaces to be used on a tunnel-server port.
Specify an integer in the range 0–16000 to provision the maximum number of
tunnel-service interfaces.
Use the all-available keyword to provision the maximum number of
tunnel-service interfaces to match the maximum value that the tunnel-server
module supports.
Examples
host1(config-tunnel-server)#max-interfaces 5000
host1(config-tunnel-server)#max-interfaces all-available
Use the default version to restore the default configuration. On dedicated
tunnel-server ports, the default configuration is the maximum number of
tunnel-service interfaces that the service module supports (all-available). On
shared tunnel-server ports, the default configuration is zero tunnel-server
interfaces.
Use the no version to reduce the number of provisioned tunnel-service interfaces
to zero. Issuing the no max-interfaces command has the same effect as issuing
the max-interfaces 0 command.
See max-interfaces.
Use from Global Configuration mode to specify the physical location of the
tunnel-server port that you want to configure.
The tunnel-server command accesses Tunnel Server Configuration mode, which
enables you to provision the maximum number of tunnel-service interfaces to
be used on the tunnel-server port.
For ERX7xx models, ERX14xx models, and the ERX310 router , use the slot/port
format.
For the E120 and E320 Broadband Services Routers, use the slot/adapter/port
format. On dedicated tunnel-server ports, use adapter 0 and port 0. On shared
tunnel-server ports, use adapter 2 and port 0.
Example
host1(config)#tunnel-server 12/2
Use the default version to restore the default configuration. On dedicated
tunnel-server ports, the default configuration is the maximum number of
Configuring Tunnel-Server Ports and Tunnel-Service Interfaces
Chapter 6: Managing Tunnel-Service and
IPSec-Service Interfaces
227

Advertisement

Table of Contents
loading

This manual is also suitable for:

E series

Table of Contents