Table of Contents
Advertisement
Sync count Number of times the pattern detector synchronized with
the incoming data pattern
Received bit count Number of bits received
Error bit count Number of bits with errors
Number of valid intervals Number of 15-minute intervals since the line
module was last powered on or reset
Time elapse in current interval Statistics are reported in 15-minute intervals
Errored seconds Number of errored seconds encountered by a T1 in the
current interval
Severely errored seconds Number of severely errored seconds encountered
by a T1 in the current interval
Severely errored frame seconds Number of severely errored framing
seconds encountered by a T1 in the current interval
Unavailable seconds Number of unavailable seconds encountered by a T1
in the current interval
Clock slip seconds Number of clock slips encountered by a T1 in the current
interval
Path code violations Number of coding violations encountered by a T1 in
the current interval
Line errored seconds Number of line errored seconds encountered by a
T1 in the current interval
Bursty errored seconds Number of bursty errored seconds encountered by
a T1 in the current interval
Degraded minutes Number of minutes that a T1 line is degraded
Line code violations Number of line code violations encountered by a T1
in the current interval
Example 1 In this example, a T1 channel and the brief keyword are specified.
host1#show controllers t1 2/0:1 brief
DS3 2/0:1
ifOperStatus = ifOperUp
Yellow Alarm detection is active
Yellow Alarm generation is active
snmp trap link-status = disabled
Framing is D4, Line Code is Ami, Clock Source is Internal - Module
Allocated Ds0 time slot map = 0x0
Loopback Enabled - Diagnostic
Last Remote Loopback Request Sent - Deactivate
FDL is not configured
FDL Transmit Path-Id is not active
FDL Transmit Test-Signal is not active
FDL Transmit Idle-Signal is not active
Chapter 1: Configuring Channelized T3 Interfaces
Monitoring Interfaces
35
Advertisement
Table of Contents
