Juniper PHYSICAL LAYER - CONFIGURATION GUIDE V11.1.X Configuration Manual page 122

Junose software for broadband services routers
Table of Contents

Advertisement

JUNOSe 11.1.x Physical Layer Configuration Guide
100
Monitoring SONET/SDH Interfaces
chassis Internal clock is from the configured router clock
Receive FIFO Overruns Number of times received FIFO was overrun
Current section defects Number of suspect bit patterns found in several
consecutive frames in section layer
Current line defects Number of suspect bit patterns found in several
consecutive frames in line layer
Received SONET overhead Section and line overhead bytes present in the
receive side of the interface at any particular time
Transmitted SONET overhead Section and line overhead bytes present in
the transmit side of the interface at any particular time
Channel configuration Parameters for specific controllers. The actual
parameters depend on the controller.
ifAdminStatus State of the controller in the software configuration: up
or down
snmp trap link-status State of SNMP link status processing for the path
layer: enabled or disabled
alarms used for operational status calculation Types of defects that the
router uses to determine the operational status of the interface at the
path layer
defect trigger soaking delay Time that the router waits to set an alarm
when the router records a defect at the path layer
c2 byte Setting of path signal byte: set by upper interface type
(automatic setting) or configured value
Operational Status Physical state of the controller: up, down, or
lowerLayerDown
time since last status change: time the controller has been in the current
physical state
Received SONET Path overhead Path overhead bytes present in the receive
side of the interface at any particular time
Transmitted SONET Path overhead Path overhead bytes present in the
transmit side of the interface at any particular time
Example
host1# show controllers sonet 1/0
oc3 1/0
non channelized
ifAdminStatus: up
description: link1
snmp trap link-status: enabled
alarms used for operational status calculation: LOS LOF AIS RDI
defect trigger soaking delay: 2500 milliseconds
Operational Status: down, failure alarm: AIS

Advertisement

Table of Contents
loading

This manual is also suitable for:

E series

Table of Contents