Juniper PHYSICAL LAYER - CONFIGURATION GUIDE V11.1.X Configuration Manual page 15

List of Figures
Part 1
Chapter 1
Chapter 2
Chapter 3
Chapter 4
Chapter 6
Chapters
Configuring Channelized T3 Interfaces
Figure 1: Stack for Channelized T3 Interface ...................................................7
Figure 2: T1 Channels and DS0 Timeslots on a T3 Line ...................................8
Configuring T3 and E3 Interfaces
Figure 3: Stack for T3 ATM Interfaces ............................................................49
Figure 4: Stack for T3 Frame and E3 Frame Interfaces ..................................49
Configuring Unchannelized OCx/STMx Interfaces
Figure 5: Interface Stack for OCx/STMx/DS3-ATM Interfaces .........................78
Figure 6: Interface Stack for OCx/STMx POS and OC48/STM16
Interfaces ................................................................................................79
Figure 7: Interface Stack for OCx/STMx POS Interfaces .................................81
Configuring Channelized OCx/STMx Interfaces
Figure 8: Stack for cOCx/STMx Interfaces ....................................................113
Figure 9: SONET Multiplexing ......................................................................114
Figure 10: SDH Multiplexing ........................................................................115
Figure 11: Configuring Fractional T1 in SONET Mode ..................................142
Figure 12: Configuring Fractional E1 and Unframed E1 in SDH Mode .........143
Managing Tunnel-Service and IPSec-Service Interfaces
Figure 13: Interface Stacking for Tunnel-Service Interfaces .........................215
3
45
73
109
215
xv
List of Figures