Table of Contents
Advertisement
JUNOSe 11.1.x Physical Layer Configuration Guide
path ds1|e1 channel-group shutdown
path ds1|e1 channel-group snmp trap link-status
path ds1|e1 channel-group timeslots
126
Configuration Tasks
The description or alias can be a maximum of 80 characters.
Use "show controllers sonet ds1|e1" on page 159 to display the text description.
Example
host1(config-controller)#path 10 e1 1/5/1 channel-group 4
description westford e1 151.4
Use the no version to remove the text description or alias.
See path ds1|e1 channel-group description.
Use to disable a T1 or an E1 channel group.
T1 and E1 channel groups are enabled by default.
Example
host1 (config-controll)#path 12 e1 1/4/1 channel-group 2 shutdown
Use the no version to restart a disabled channel group.
See path ds1|e1 channel-group shutdown.
Use to enable SNMP link status processing for a T1 or an E1 channel group.
The default is disabled.
Example
host1(config-controll)#path 2 ds1 1/1/1 channel-group 2 snmp trap link-status
Use the no version to disable SNMP link status processing for a T1 or an E1
channel group.
See path ds1|e1 channel-group snmp trap link-status.
Use to configure T1 or E1 line parameters.
You cannot configure a mixture of T1 and E1 lines on the same cOCx/STMx line
module.
Specify a T1 or E1 channel group number, and assign a range of timeslots.
To configure a whole T1 or E1 line, assign all the timeslots to the channel group.
You can specify a line speed that applies to all DS0 timeslots assigned to a channel
group.
Example
host1(config-controll)#path 2 ds1 1/1/1 channel-group 2 timeslots 5-6
Advertisement
Table of Contents
