Juniper PHYSICAL LAYER - CONFIGURATION GUIDE V11.1.X Configuration Manual page 225

interface tenGigabitEthernet
NOTE: On the ES2-S2 10GE PR IOA, you can configure only the primary port, 0. The
router automatically uses the redundant port, 0R, if the primary port fails.
ip mac-validate
NOTE: For additional information about MAC address validation, see the arp validate
command description in JUNOSe IP, IPv6, and IGP Configuration Guide.
load-interval
Use the no version to remove IP from an interface. You must issue the no version
from the highest level down; you cannot remove an interface or subinterface if
the one above it still exists.
See interface gigabitEthernet.
Use to select a 10-Gigabit Ethernet interface on the E120 or E320 router.
Use the slot/adapter/port format.
Example Selects a 10-Gigabit Ethernet interface on the ES2-S1 10GE IOA
host1(config)#interface tenGigabitEthernet 4/0/0
Use the no version to remove IP from an interface. You must issue the no version
from the highest level down; you cannot remove an interface or subinterface if
the one above it still exists.
See interface tenGigabitEthernet.
Use to enable or disable MAC address validation on a per interface basis.
Use the strict keyword to prevent transmission of IP packets that do not reside
in the validation table.
Use the loose keyword to enable IP packets to pass through even though the
packets do not have entries in the validation table. Only packets that have
matching IP–MAC pair entries in the table are validated.
The default behavior is not to perform MAC address validation.
Example
host1(config)#interface gigabitEthernet 2/0
host1(config-if)#ip address 4.4.4.2 255.255.255.0
host1(config-if)#ip mac-validate strict
host1(config-if)#exit
Use the no version to disable the command.
See ip mac-validate.
Chapter 5: Configuring Ethernet Interfaces
Configuring the Physical Interface
203