Table of Contents
Advertisement
NOTE: The alarms detected field does not appear for interfaces that you disabled in
the software.
framing Type of framing format
line code Type of line code format
clock source Type of clock source
cable length Cable length, in feet
Loopback State of loopback for the controller: enabled or disabled. If
loopback is enabled, one of the following states is displayed:
Diagnostic Loops the data back toward the router and sends an AIS
toward the network
Payload Loops the data toward the network after the framer has
processed the data
Line Loops the data toward the network before the data reaches the
framer
MDL Transmit Path Status of path transmission: active or not active
MDL Transmit Test-Signal Status of test signal: active or not active
MDL Transmit Idle-Signal Status of idle signal: active or not active
Equipment Identification Code eic string for MDL
Line Identification Code lic string for MDL
Frame Identification Code fic string for MDL
Unit Identification Code unit string for MDL
Facility Identification Code pfi string for MDL
Port Code port string for MDL
Generator Number generator string for MDL
BERT test Number of current test and total number of tests
Test interval Length of the BERT test
status Sync (controller is synchronized with remote device) or NoSync
(controller is not synchronized with remote device)
Sync count Number of times the pattern detector synchronized with
the incoming data pattern
Received bit count Number of bits received
Error bit count Number of bits with errors
Chapter 1: Configuring Channelized T3 Interfaces
Monitoring Interfaces
31
Advertisement
Table of Contents
