Table of Contents
Advertisement
sdh
snmp trap link-status
trigger delay
Specify a value of 0 milliseconds if this interface does not use APS/MSP or
if MPLS should have priority over APS/MSP.
Specify a value of at least 100 milliseconds if this interface uses APS/MSP
and if APS/MSP should have priority over MPLS.
Example
host1(config-controll)#path 2 trigger delay msec 1000
Use the no version to restore the default setting, 2500 milliseconds.
See path trigger delay.
Use to specify that the interface supports SDH.
Example
host1(config-controller)#sdh
Use the no version to revert to SONET operation on this interface.
See sdh.
Use to enable SNMP link status processing for the section and line layers of the
interface.
The default is enabled.
Example
host1(config-controll)#no snmp trap link-status
Use the no version to disable SNMP link status processing.
See snmp trap link-status.
Use to set the time duration after which the router sets an alarm when it records
a defect at the line or section layer.
Change this value from the default only when you are using MPLS fast reroute
over a SONET/SDH interface.
Specify a value of 0 milliseconds if the interface does not use APS/MSP or if
MPLS should have priority over APS/MSP.
Specify a value of at least 100 milliseconds if this interface uses APS/MSP
and if APS/MSP should have priority over MPLS.
Example
host1(config-controll)#trigger delay msec 1000
Chapter 4: Configuring Channelized OCx/STMx Interfaces
Configuration Tasks
123
Advertisement
Table of Contents
