Juniper PHYSICAL LAYER - CONFIGURATION GUIDE V11.1.X Configuration Manual page 252

JUNOSe 11.1.x Physical Layer Configuration Guide
230
Monitoring Tunnel-Service Interfaces
Example 2 Displays information about a dedicated tunnel-server port on an
ISM
host1#show tunnel-server
Card
Port:Appl Type
--------------- ---------
Port 2/0 dedicated
ipsec-tunnel
ipsec-transport
l2tp
gre/dvmrp
Appl Totals
ipsec-tunnel
ipsec-transport
l2tp
gre/dvmrp
total
Example 3 Displays information about a specific shared tunnel-server port
host1#show tunnel-server 2/2
Card
Port:Appl Type
--------------- ---------
Port 2/2 shared
ipsec-tunnel
ipsec-transport
l2tp
gre/dvmrp
Example 4 Displays configuration information about dedicated and shared
tunnel-server ports
host1#show tunnel-server config
Port Type
-------- -------
Port 2/2 shared
Port 8/0 dedicated
See show tunnel-server.
Oper Active
State Interfaces Interfaces Fill
------- ----------
present 1
up 0
down 0
down 0
up 1
0
0
0
2
2
Oper Active
State Interfaces Interfaces Fill
------- ---------- ---------- ----
present 0
down 0
down 0
up 0
up 0
Server Ports
------------
Provisioned
MaximumInterfaces Interfaces
----------------- -----------
8000 4000
16000 16000
Max
---------- ----
8000 0.0%
0 0.0%
0 0.0%
8000 0.0%
4000 0.0%
0 0.0%
0 0.0%
16000 0.0%
8000 0.0%
16000 0.0%
Max
4000 0.0%
0 0.0%
0 0.0%
4000 0.0%
4000 0.0%
HwPresent
---------
yes
yes