7.
For information about the ip pim join-filter command, see Configuring PIM for IPv4
Multicast in JUNOSe Multicast Routing Configuration Guide. For information about the
ipv6 pim join-filter command, see Configuring PIM for IPv6 Multicast in JUNOSe
Multicast Routing Configuration Guide.
Clearing Access List Counters
Use the clear access-list or clear ipv6 access-list commands to clear access list
counters.
clear access-list
clear ipv6 access-list
Creating Table Maps
For static routes and access routes, you can configure and apply a table map that
filters routes before an access list adds them to the routing table. For static routes,
you can use the ip static-route table-map or ipv6 static-route table-map command.
For access routes, you can use the ip access-route table-map or ipv6 access-route
table-map command.
Use these commands when triggering on the policy values listed in Table 3 on
page 32.
Enable PIM sparse mode on another subinterface and assign the gold join filter.
host1(config-if)#interface atm 3/0.103
host1(config-if)#ip address 103.0.0.1 255.255.255.255
host1(config-if)#ip pim sparse-mode
host1(config-if)#ip pim join-filter gold
Use to clear all access list counters or access list counters in the specified access
list.
Example 1
host1#clear access-list list1
Example 2
host1#clear ipv6 access-list list2
There is no no version.
See clear access-list.
See clear ipv6 access-list.
Chapter 1: Configuring Routing Policy
Access Lists
31