Cisco ISE - Line Card ISE Configuration Manual page 93

Software Configuration of ATM ISE Line Cards for Cisco 12000 Series Routers
police rate
To configure traffic policing, use the police rate command in policy-map class configuration mode. To
remove traffic policing from the configuration, use the no form of this command.
Syntax Description
pcr
scr
cps
cells
atm-mbs
mbs
delay-tolerance
cdvt
conform-action
exceed-action
police rate pcr cps delay-tolerance cdvt conform-action action exceed-action action
violate-action action
police rate scr cps atm-mbs mbs cells conform-action action exceed-action action violate-action
action
no police rate {pcr | scr}
Peak cell rate, specified for hierarchical policies. Valid values are 7 to
10,000,000,000.
Sustainable cell rate, specified for single-level ATM 4.0 policies. Valid
values are 7 to 10,000,000,000.
Optional. Indicates that the rate value is in cells per second. If this keyword
is not used, then bits per second (bps) is assumed.
Indicates that the burst value is in units of cells. This option is only available
if the cps keyword is used.
Indicates that the ATM maximum burst size follows.
Maximum burst size in numbers of cells. Valid values are 1 to 5,000,000.
(Optional) Indicates that the cell delay variation tolerance follows.
Cell delay variation tolerance specified as the number of microseconds.
Action to take on packets that conform to the rate limit.
Action to take on packets that exceed the rate limit.
police rate
Cisco IOS Release 12.0(27)S
93