Cisco ISE - Line Card ISE Configuration Manual page 16

How to Configure Layer 3 Terminated VCs on the 4-Port ATM ISE Line Card
Command or Action
Step 11
interface atmslot/port.subifnum
Example:
Router(config)# interface atm1/0.1
pvc vpi/vci
Step 12
Example:
Router(config-subif)# pvc 10/50
Step 13
service-policy {input | output} policy-name
Example:
Router(config-if-atm-vc)# service-policy input
police
The command syntax of the police command allows you to specify the action to be taken on a packet
when you enable the action keyword. The actions resulting from the keyword choices are listed in
Table
Table 5
Keyword
drop
set-clp-transmit
set-discard-class-transmit
new-class
set-dscp-transmit dscp
set-mpls-exp-imposition-transmit
mpls-exp
set-mpls-exp-topmost-transmit
mpls-exp
set-prec-transmit new-prec
set-qos-transmit new-qos
transmit
Configuring a Per-VC Queue Limit
Use this task to configure a per-VC queue limit on a single egress or ingress queue.
Restrictions
A queue limit cannot be configured together with WRED.
Cisco IOS Release 12.0(27)S
16
5.
police Command Action Keywords
Software Configuration of ATM ISE Line Cards for Cisco 12000 Series Routers
Purpose
Specifies the ATM subinterface to configure.
Specifies the ATM PVC to attach the traffic policy to.
Attaches the traffic policy to the PVC.
Resulting Action
Drops the packet.
Sets the ATM CLP bit and sends the packet. This is supported
for egress only.
Sets the discard-class and sends the packet. This is supported for
ingress on terminated VCs only.
Sets the differentiated services code point (DSCP) value and
sends the packet.
Sets the experimental value at tag imposition and sends the
packet. This is supported for ingress on terminated VCs only.
Sets the experimental value on the topmost label and sends the
packet. This is supported on terminated VCs only.
Sets the IP precedence and sends the packet.
Sets the QoS group and sends the packet. This is supported for
ingress only.
Sends the packet.